02-07-2018 09:39 AM
my Crucial MX500 SSD keeps 'freezing' at randon time intervals and won't allow me to do anything until I switch the PC off and reboot.
It does this completely without any warning, I could be surfing the net or working on an important project and lose all work I've done since last being able to safely save my work.
I've only had the SSD drive a couple of weeks and have to say I'm very disappointed with it so far.
I have since replaced it with my old HDD and ha dno such freezing problems since.
Has anyone else had similar problems, is there a fix or have I been sold a faulty SSD?
02-07-2018 01:48 PM
Drives have built in diagnostic data known as SMART which should alert you as to whether the drive itself is faulty or not. You can check this data in http://uk.crucial.com/gbr/en/support-storage-executive
If you're not sure what you are looking at, post up a screenshot from that program and we can take a look.
And if the drive is not faulty, here's some past causes of such issues:
i) The Acronis cloning software included with the drives can cause this behaviour on a minority of systems and if affected should be uninstalled after you have cloned. However, I say this without knowing whether the MX500 includes this software or whether it is affected - since it uses a different controller to the older drives.
ii) Chipset power saving. If you have the option - enable hot swap for the sata port the drive is connected to in your BIOS. Try setting the windows power options to high performance.
iii) Sata drivers. If using the Windows stock ones, try swapping to your chipset manufacturers driver and vice versa and even different versions of the manufacturers driver. Intels is here: https://downloadcenter.intel.com/product/55005 You may need to select an older version for older computers.
03-19-2018 11:45 AM
Pleas then follow the above advice and if it doesn't help, post up SMART data. I assume it helped the OP since we never heard back so hopefully it will help you too.
04-13-2018 11:18 PM
I have the same problem… After cloning and installing the new Crucial MX500 SSD hard drive… Also freezing, mostly when using Internet Explorer. During a period of exasperation, I did a complete reset of windows 10, after which the SSD worked flawlessly. Of course the problem is that I have lost all of my applications. I am now trying the entire process over again, because I would like to get my apps back… So I I am in the process of re-cloning my original Samsung SSD, and when I reinstall the new crucial SSD, I am hopeful that I can find another fix without having to do a complete windows reset again.
04-13-2018 11:58 PM
Did you uninstall Acronis after cloning? That's typically the problem. The cloning software itself causes issues on some computers. The act of resetting Windows would definetly have removed it.